Toy rocket launcher from syringes with remote control

This is a very interesting and simple toy rocket launcher. Any teenager will be delighted with the game with her. Personally, I am already quite an adult, and then with joy I launch rockets from this amazing design. Fuel for rocket launchers are ethyl alcohol. Rockets soar into the air with a perky slam, which looks very impressive.

It will be needed to make a rocket launcher

I will make a rocket launcher of four rockets, therefore, the fashion below is multiplied four times. You can make one rocket.
  • Disposable syringe. I took 60 ml.
  • Used a lighter with a piezoelectric element.
  • A two-core wire 1-2 meters long.
  • Small ones stand plates.
  • Hot glue gun.
  • Soldering iron, stationery knife, ruler, and other available tools.
Toy rocket launcher from syringes with remote control

Making a toy rocket launcher

We takelighter and disassemble it, in order to pull out the piezoelement that generates a spark - a discharge of igniting gas.
Toy rocket launcher from syringes with remote control We take out the piezoelectric element. This is the high-voltage generator itself. A wire is one contact, and the second is a shiny cap from below.
Toy rocket launcher from syringes with remote control
We take two-wire wire. It is advisable to choose with thicker insulation.
Toy Rocket Launcher with Remote Controlled Syringes
We connect to a piezoelement. Toy rocket launcher with remote control syringesToy rocket launcher from syringes with remote control Then we isolate everything with tape or, better than me, with heat shrinkage. We take two needles from syringes. Here I want to warn you and offer either to whittle off the needle point with a needle file or just to bite off the floor a centimeter with pliers. This must be done, because during the period of the game you can get hurt. Connect the wires to the needles.These will be electrodes that will be inside the rocket launcher.
A toy rifle with syringes with remote control
Solder for reliability. But this does not necessarily .
Toy rocket launcher from syringes with remote control
Take the syringe and take out the piston.
Toy rocket launcher from syringes with remote control
Remove the rubber seal from the piston.
Toy rocket launcher from a syringe with remote control
soldering iron to make holes in the piston
Toy rocket launcher from a syringe with remote control
put in these holes, our needle electrodes
Toy rocket launcher from syringes with remote control
Fill with hot glue to seal.
Toy rocket launcher from syringes with remote control
Rubber sealant is taken. Cut off the top with a stationery knife.
Toy rocket launcher from syringes with remote control
We put on the modified piston with electrodes.
Toy rocket launcher from syringes with remote control
Fill the cylinder bore with hot glue. We don’t need it anymore.
Toy rocket launcher from syringes with remote control
Cutting the cylinder skirt of the syringe.
Toy rocket launcher from syringes with remote control
Toy launcher with syringes with remote control
Take a hard cardboard or plastic. And we cut out from here such flight stabilizers of a rocket.
Toy rocket launcher from syringes with remote control
Bending back slightly.
Toy Rocket Launcher with Remote Controlled Syringes
We need four pieces per missile. Glue to cylinder.
Toy rocket launcher from syringes with remote control
Putting together a rocket launcher.
Toy rocket launcher from syringes with remote control
I made four such rocket launchers.
Toy rocket launcher from syringes with remote control
Affairs stand for the whole thing. I took a rectangular plank and drilled two small holes in the middle of the second half. You will understand why a little later.
Toy rocket launcher from syringes with remote control
Next, take the second plank, but smaller. We drill in the center of the hole for wires. Glue with hot glue obliquely. See the photo.
Toy rocket launcher from syringes with remote control
Glue all the rocket launchers.
Toy rocket launcher from syringes with remotecontrol
 Toy rocket launcher from syringes with remote control
 Toy rocket launcher from syringes with remote control
Behind the wires we fasten all four wires with a nylon coupler.
 Toy rocket launcher from syringes with remote control
Remote of the management station is also a board with piezo elements glued to it on a hot glue.
 Toy rocket launcher from syringes with remote control
The rocket launcher is ready.
 Toy rocket launcher from syringes with remote control
Getting down to the game. To fill our rockets with fuel we take perfume or cologne. We remove each cylinder and pshikayem spirits into it 1-2 times and then we put the rocket back on. Inside there is now a mixture of alcohol.
Toy rocket launcher from syringes with remote control
Toy rocket launcher from syringes with remote control
In order to launch a rocket, click on the piezoelectric element.Inside the rocket, a spark jumps and the mixture ignites. As a result, the rocket takes off. Everything is accompanied by a small pop. The rocket flies 5-10 meters.
Toy rocket launcher from syringes with remote control
Toy rocket launcher from syringes with remote control
Toy rocket launcher from syringes with remote control
Toy rocket launcher from syringes with remote control

Watch the video

More detailed instructions for assembling and testing the rocket launcher can be seen in this video. In the manufacture and game do not forget about the precautions. Although it is a toy, you can harm yourself if you neglect it. So do not forget that all responsibility lies only on you.
Date: 08.10.2018, 21:47 / Views: 94162

Related News


How to lose weight by 20 kg per month
Coffee Brown Snowman
Homemade Oatmeal Cookies
Where is the best way to spend a birthday at 14
How to cook chickpeas
Superman's knapsack of plastic bottles. Crafts for the Day of Cosmonautics
Hypersensitivity and sensitivity: what to do