How to shorten the bolt
Practical advice and useful trick, how to shorten a bolt, stud or screw. The fact is that if you cut the thread in the usual way, then tighten the nut back on the thread will not work. All this is due to the fact that the threaded turns are crushed.To avoid this, there is a simple way out.Screw 1-2 nuts on the bolt for the applied risk. In general, the nuts should be on the side, which you will need later.Now cut off. Depending on the thickness, this can be done in severalways:I bit off the pliers, because the screw is thin. Of course this is the roughest method, but the fastest.Now hold the nut with pliers and turn the screw with a screwdriver. This is the whole trick: after turning the nut, it will straighten all the threads on the cutting tip.
You will need
- A bolt, stud or screw that must be cut and shortened.
- Nut, 1-2 pcs, with the same thread.
We cut off the bolt, stud or screw correctSo, I will take a screw for example. Marker notice the place to cut. Measuring with a ruler.
- Bite off with nippers.
- Cut with a grinder.
- Saw with a hacksaw.
- Clamp in the screwdriver and rotate the bolt saw off with a hacksaw.
- Or in another way.
Date: 09.10.2018, 12:36 / Views: 84384
How to choose a phone
Robbie Williams talked about his illness
Caesar with shrimps